Temperature Control.... HELP

FiremanMikeD

Hey Gang, 

Running a bit behind the 8 ball. I lit my LBGE, and went inside to pull the membrane off some BBribs while I waited for it to set up. Well, I had a stubborn one, and next thing I knew the egg is roaring at 375. I got it down to 250, but when my drip pan of Apple Juice/Apple cider vinegar and the 4 slabs of ribs went in, the dome temp dropped and is holding at 200. I know, patience is the name of the game, but was WAAAAAYYYYYY late with a brisket last week. So the wife is already teasing me. 

Dare i open the bottom vents to get the temp up and then try to catch it?? Thoughts?

We need to eat in about 4 hours

Foghorn

First question.  Do you know what settings usually set you in at 250-275 when you have a platesetter and some meat?

bigalsworth

When you put meat on the temp normally drops and then bounces back, but if you haven't got your ceramic nice and heat soaked it can take a little longer to get back. I would give it a bit but you can probably open your vents a bit just to help it out and then set them back to normal after it recovers

SoCalTim

Do not open the bottom vent, use the Daisy Wheel to slowly bring the temp up. Remember, you tell the egg what to do, it doesn't tell you

This is not a problem ... 

Legume

It will come back to 250 once the meat and cider comes up to temp, but you won't be eating ribs in 4 hours at 250.  Open it a little, maybe 1/8".  I think you probably need to be at least 300.

TexanOfTheNorth

If you do open the vent (bottom or top) keep a close eye on it... once it starts to go back up you want to adjust to your normal settings (pretty quickly) for the temp you're aiming for. Don't be surprised if you find yourself chasing your temp for this cook.

Legume

Now you just need a 4 sided coin to flip for what to do.  Good luck, I'm sure any of the advice would work out.  Lots of ways to do this.

FiremanMikeD

Thanks to all! I did open it a bit, and my ceramic took hold shortly thereafter. I am running a grate temp of about 250 and a dome temp at 275. I think I'm in my happy place. Appreciate you all... hope a good saturday cook is in your future. 

TexoftheNorth... I guess I'll have to sit close by with a cold beer and keep a close eye on it. SoCalTim, and Legume, made me chuckle out loud.

Thanks again guys!

TexanOfTheNorth

FiremanMikeD said:

Thanks to all! I did open it a bit, and my ceramic took hold shortly thereafter. I am running a grate temp of about 250 and a dome temp at 275. I think I'm in my happy place. Appreciate you all... hope a good saturday cook is in your future. 

TexoftheNorth... I guess I'll have to sit close by with a cold beer and keep a close eye on it. SoCalTim, and Legume, made me chuckle out loud.

Thanks again guys!

Well, somebody's got to do it!

SoCalTim

@FiremanMikeD  .. once you get a bunch of cooks under your belt, you'll know exactly where 275 , 300 & 350 are on your lower vent and daisy wheel. Took me a while to finally get a grasp on things.

pescadorzih

I think to be ready in 4 hrs you'll need to bump up the heat a little.  325-350 temp range 

lousubcap

A factor the will impact any cook...liquid in a drip pan.  The liquid acts as a heat-sink effectively keeping temps in close vicinity to around the boiling point of water.  Once the liquid has evaporated, the sink is gone and temps will rise to the natural air-flow level for a non- drip panned cook.  FWIW-