OT any math whizes out there?

"Sparky"

Hey guys,I am building a transporter for my medium egg,and need some help.The circumference? is 54" around.What is the diameter?I am seriously brainfarting this morning Thanks,

Richard Fl

My brain is still water logged from Fay. Try this link.

http://www.onlineconversion.com/circlesolve.htm

Mike in Abita

17.188733853924695

Celtic Wolf

17.20 inches..

However you want to leave some space between the outside of the egg and the edge of the table. 1/2" minimum.

So it's closer to 17.7"

"Sparky"

Thanks guys,17.2 it is :woohoo:

Celtic Wolf

17.7 it is..

Re-read my post

"Sparky"

Thanks Pete

Semolina Pilchard

Just in case you have not thought of it, I would suggest the hole be level with the widest part of the egg.

Celtic Wolf

Actually up want a wee bit lower or you won't have anything to hold on to when you drop the egg in.

If you keep the table below the hinges you don't need to accommodate for the hinge assembly.

Zippylip

at this rate it may be easier to buy a new one where you are going

Semolina Pilchard

Thanks for catching that. I just went out and looked at my egg and table. It is not good to always go from memory when a short walk will let you eyeball it.

BENTE

thanks for that link

Celtic Wolf

Richard!!

This might help

:evil:

Richard Fl

Used to dive with the SEALS in the late '60's, with twin 72's aluminum, but now I think I need a hard hat to get all this D#&^$ water out of Florida. What a mess.

thirdeye

In skool, they try to learn you to memorize Pie r squared to figure the area of a circle. But if you think about it, pie are round.....cornbread are square.

"Sparky"

Hey Thirdeye,it sounds like we went to the same "skool" :silly: :laugh: Except I lernt that lasagna R square :silly: