Welcome to the EGGhead Forum - a great place to visit and packed with tips and EGGspert advice! You can also join the conversation and get more information and amazing kamado recipes by following Big Green Egg to Experience our World of Flavor™ at:
Facebook  |  Twitter  |  Instagram  |  Pinterest  |  Youtube  |  Vimeo
Share your photos by tagging us and using the hashtag #BigGreenEgg.

Want to see how the EGG is made? Click to Watch

Small Egg Question

Options
Pork Butt Mike
Pork Butt Mike Posts: 2,584
edited November -1 in EggHead Forum
Looking to cut hole in table for the small egg. Does anyone have the size hole that should be cut. I like to work on my table now before I get my demo from Fl. Egg Fest. Thank You all for any help you can give.
· Share on FacebookShare on Twitter

Comments

  • Unknown
    Unknown
    Options
    According to the Whzz's site 16" diameter is correct. Also be sure lid opening has enough clearance to the table top. Checkout the nakedwhiz.com
    · Share on FacebookShare on Twitter
  • WessB
    WessB Posts: 6,937
    Options
    The size of the hole is directly relative to kow far down into the table the egg will sit...If you look at the small transporter in my "tips" section you should notice that the hole in the transporter will be smaller than the one in MY table, because I made the egg sit further down in my table top....hope this makes some sense...might could get ya some measurements, but not until this evening..
    · Share on FacebookShare on Twitter

Categories