Anyone know what size these are?

scottypinthemix

Like an idiot, didn't put a towel or anything down on the deck.  Dropped a nut/bolt.  Thanks!

GrateEggspectations

Maybe @HannahGreeneEgg can help you with this one or otherwise refer you to someone who can. 

Buckwoody Egger

someone may say “did you drop the other one too?” if not take it to the hw store. 

the used pull stand i have “waiting for an egg” was easy to get to. it’s an m6 12mm with a cap nut and blue thread lock on the bolt. i would buy an m6 16mm and a lock nut. the 16mm is longer than original but there’s room and the lock nut will catch. 

not sure if you completely tighten that bolt once install is done but having it locked while loose enough to allow the arms to move a bit ( the parts f and g in the illustration) is probably helpful. 

HannahGreeneEgg

scottypinthemix said:

Like an idiot, didn't put a towel or anything down on the deck.  Dropped a nut/bolt.  Thanks!

Hey There! I've got our customer support team on the case - we might have a replacement here at the office we can send. Standby! 

GrateEggspectations

HannahGreeneEgg said:

scottypinthemix said:

Like an idiot, didn't put a towel or anything down on the deck.  Dropped a nut/bolt.  Thanks!

Hey There! I've got our customer support team on the case - we might have a replacement here at the office we can send. Standby! 

Amazing. Thanks for the responsiveness, Hannah. 

HannahGreeneEgg

scottypinthemix said:

Like an idiot, didn't put a towel or anything down on the deck.  Dropped a nut/bolt.  Thanks!

Hey Scott - I reached out to you via DM to get your address! We have replacements we can send you from the office. 

bluebird66

Great service Hannah!