Big Green Egg - EGGhead Forum - The Ultimate Cooking Experience...
Welcome to the EGGhead Forum - a great place to visit and packed with tips and EGGspert advice! You can also join the conversation and get more information and amazing recipes by following Big Green Egg at:

Facebook  |  Twitter  |  Instagram  |  Pinterest  |  Youtube  |  Vimeo
Share your photos by tagging us and using the hashtag #EGGhead4Life.


In Atlanta? Come visit Big Green Egg headquarters, see our new showroom and check out the History of the EGG Museum and Culinary Center!  3786 DeKalb Technology Parkway, Atlanta, GA 30340.

XL spring adjustment

City SlickerCity Slicker Posts: 95
edited 1:08PM in EggHead Forum
XLspring.gif
<p />I found that by loosening the bolt on this spring tab a bit when the egg is closed, the spring pressure will pull the tab back towards the rear of the egg. This vastly reduced my rear gap. Re-tighten of course. Still get a good spring assist with the tab in less then the vertical position as shown. I did this with the intent of re-aligning the top lid with the bottom, as the top was pulled back from the bottom a bit. I was surprised to see the gap get reduced too.

Comments

  • BOBFBOBF Posts: 177
    City Slicker,[p]Thanks. I may give the assists one more try.

  • mikeb6109mikeb6109 Posts: 2,067
    City Slicker,
    great i hope this helps cause was very disapointed with my xl due to that big gap at the rear. had taken my assit off to get rid of it so will try and hope this does works!
    mike

Sign In or Register to comment.
Click here for Forum Use Guidelines.