New Table For The Small:

Pork Butt Mike · September 2010

This is the new table Dan design for the small. Dealer we use for the Sunshine State Egg Fest over in Melbourne, Fl.

He did a great job on the table but I screwed it up. I put on the polyurethane on it and it bubble up in some spots. I not sure if it was the humidity or what. :ohmy:

Swantho · September 2010

It's perfect! And, thumbs-up on the Phin's logo!

Bacchus · September 2010

Very nice!

Double Bogey · September 2010

Nice Mike. If you are unhappy with the way the finish turned out you can always sand it down and re-coat under better conditions.

Pork Butt Mike · September 2010

Thinking about that Larry, but again its just a BBQ Table. Hope you and Vickey are doing ok. Tell her we say hi.

Mickey · September 2010

Real nice Mike.

Capt Frank · September 2010

I ordered one from Dan also Mike, got it set up today, will post pics later.
Did you shake your Urethane? Big no-no, just like 007, stirred, not shaken, those pesky air bubbles you know :P :silly: :laugh:

Wazoo · September 2010

What does one of these cost?

Pork Butt Mike · September 2010

Hey Frank how you all doing now. No I did not shake I just stired it up and there was no air bubbles at all in the can. I never did like finished work anyway. LOL

Serial Griller · September 2010

Nice looking table! Perfect for the small.
Just resand and finish on a dryer day.
How's that wide receiver for the Dolphins that used to be in Denver doing???

What's his name??? :cheer:

Pork Butt Mike · September 2010

I think they are going for 199.00 dollars. Whats nice is they can be shipped. His name is Dan you can contact him danandshelly@gmail.com

Florida Grillin Girl · September 2010

Nice, Mike. Enjoy it!

Wait for a dry day?? Yeah, that will be a small window, maybe a few hours of dry weather in a 3-4 months, huh?

Wazoo · September 2010

Thanks!

Pork Butt Mike · September 2010

Yeah Faith if were lucky. :woohoo:

Jupiter Jim · October 2010

Hi Mike,
Nice to see you posting!! :side:
The table does look very bad with all those bubbles :ohmy: but don't worry your good buddy here can help. :laugh: First you need to take the egg off the table, package it up and send it to me. :laugh:
Nice Job Mike, hello to Sabrina.
Jim and Kay

thebtls · October 2010

Sand it out and recoat it. Use THIN multiple coats and the CORRECT brush is required. It will be worth the effort. Also, dry or wet sand between coats with 400 grit and cheese cloth.

thebtls · October 2010

The wipe on poly's are by far the best method for these projects nowadays. They don't bubble, go on super thin, even out, dry quickly and you can put on 3-4 coats in a day, dries hard as a rock too.

New Table For The Small:

Comments

Categories