Big Green Egg - EGGhead Forum - The Ultimate Cooking Experience...
It’s almost football season, so we’re perfecting our favorite tailgating and homegating recipes! Whether you like hamburgers, wings, brats, ribs or something cooked with beer, we have everything you’ll need for the perfect tailgate party. We always like inviting friends to join our tailgates because the EGG is about community and having fun, so make sure if you’re inviting company you make extra - the food will be gone before you know it! Don't forget dessert, either!

Big Green Egg headquarters has moved - come visit our new showroom and check out the museum and culinary center too! 3786 DeKalb Technology Parkway, Atlanta, GA 30340

Melted gasket

venona7venona7 Posts: 2
edited 7:56AM in EggHead Forum
I did a stupid thing..let the Egg get to 1000 degrees and melted the gasket and lid shut. What is the best way to open the Egg? I guess the gasket is toast (ha ha).

Comments

  • MSMMSM Posts: 6
    I just had my gasket melt also.

    I read a post on this board that suggested feeding some fire starter cubes into the bottom vent and raising the temperature as much as possible. This worked for me. I did have to feed some newspaper through the bottom as well. It got up to about 300 and I used a butter knife to slide between the top and bottom and pry the lid open. The gasket is toast, but it doesn't seem to effect the function much at all.
  • Grandpas GrubGrandpas Grub Posts: 14,226
    I always thought the reheating the egg was for releasing 'frozen' gaskets due to cold. I have now heard several times that the burn't gaskets are getting released by getting the egg warm/hot inside again.

    I hated it when the forum folks told me to just use the egg if the egg will hold low temps. After 3 burnt gaskets, I finally realized they know what the speak of...

    I am will do a Nomex replacement here in a few days/weeks/months or so - before it gets cold again for sure.

    Hope you two get this sorted out.

    GG
  • venona7venona7 Posts: 2
    Thanks so much for your help! I will try reheating tomorrow to see if it will free the lid up!
  • Grandpas GrubGrandpas Grub Posts: 14,226
    If it doesn't, jump back on and ask again.

    Something I did at one point in time was to use a very thin steak knive and I cut the gasket out. I was thinking of getting one of those 'razor' utility blades, the long straight ones, and get a pair of vice grip's and use that to 'saw' through the gasket material.

    If you do something like that make sure you don't cut, knick the ceramic surface of the egg (top or bottom).

    GG
  • HammerHammer Posts: 1,001
    Putting a couple or more starter cubes in the bottom of the egg will build up enough heat to release the dome from the base in most instances whether it is a melted gasket or if it's frozen. You can also put a couple of cubes down from the top.
    I did it today.
    Hammer
  • Grandpas GrubGrandpas Grub Posts: 14,226
    Hay, you are not supposed to have frozen gaskets!!!

    Nice to hear from you Mitch, hope all is well with you and the family.

    Thanks for the information, I didn't realize re-heating would loosen a stuck gasket from the heat side of things.

    Kent
Sign In or Register to comment.