Big Green Egg - EGGhead Forum - The Ultimate Cooking Experience...
We’re so close to Thanksgiving that we can taste it and we’re ready to help you prepare the most delicious Thanksgiving feast you’ve ever cooked! Check out our Turkey Cheat Sheet for turkey tips, our Thanksgiving page for turkey recipes, and our Holiday Entertaining Publication for all other Thanksgiving needs to help you make this the best Thanksgiving yet! PS. Don’t forget about breakfast Thanksgiving morning either!

Big Green Egg headquarters has moved - come visit our new showroom and check out the museum and culinary center too! 3786 DeKalb Technology Parkway, Atlanta, GA 30340.

New large Egg, top dome not aligned with bottom

 I just got a new large BGE,  put it together according to instructions and the official BGE video. However, the top dome sets back off the bottom dome about 1/4 inch. I looked at it from every possible angle and can't see where it is off. Any suggestions on a fix or any way to make adjustments?


  • I forgot to mention that this is in the front of the Egg, not off anywhere else. Is it possible the bottom has an out of round defect towards the front? Or is this something that would not effect its functioning?
  • My large is like that as well and I have never been able to get it perfect, even with the bands cocked a bit. I called Egg corporate and they said a little underbite like that is ok. For what it's worth.
    large and XL BGE in Richmond, VA
  • KennyLeeKennyLee Posts: 713
    My lid is about that much out of alignment too, however it shows on the front and back.  Like @vapilotda, I've tried to get it perfect to no avail.  Had it for close to a year and a half with no issues at all......good seal, still original gasket. 


    Cedar table w/granite top

    Ceramic Grillworks two-tier swing rack

    Perpetual cooler of ice-cold beer

  • Another one here with a bit of an underbite. Hasn't had any affect on my cooks as far as I can tell.
    Battle Ground, WA
    Large BGE,  MiniMax  and a Vision Kub.
    Could you call on Lady Day, could you call on John Coltrane?
  • 4Runner4Runner Posts: 2,309
    Heisenberg did it. Loosen bands, adjust and try again. Mine used to align perfectly but now I'm 1/4" off too. I stopped trying to fix it and just cook.
    Joe - I'm a reformed gasser-holic aka 4Runner Columbia, SC Wonderful BGE Resource Site: and  and
    What am I drinking now?   Woodford....neat
  • reh111reh111 Posts: 164
    My medium is like that also - not really a big problem so I haven't worried about it
  • bicktravbicktrav Posts: 467
    Don't sweat 1/4 inch.  Won't affect anything.
    Southern California
  • SkinnyVSkinnyV Posts: 2,799
    Welcome to the club...mines the same way. Not 1/4 but there's a bite.
    Seattle, WA
  • rmhendoormhendoo Posts: 35
    edited October 2013
    Thanks for the comments...the general consensus is to let it ride and get cooking! 
  • bo_mullbo_mull Posts: 348
    Mines the same way, the front has an underbite and the back is even. My top band is pulled together closer than my bottom band. I measured and decided that my dome is smaller than my base. Just make sure you have a good seal.

    Cleveland, TN.

    LG BGE, PSWOO2, Stoker WIFI.

  • TerrebanditTerrebandit Posts: 1,534
    Mine is off side to side. I have not messed with it (yet).
    Dave - Austin, TX
  • jaydub58jaydub58 Posts: 1,882

    I have a slight underbite at the front also.

    In three years I haven't noticed any problem.

    John in the Willamette Valley of Oregon
  • Thanks, I will not sweat it, it seems that this is a common figure with this much of an investment, the tolerances would be tighter, but if it doesn't affect the performance...who cares
  • johnkitchensjohnkitchens Posts: 4,097
    Hey Heisenberg mine was off when I first got it. I didn't notice it until my gasket started getting fried in the area exposed to heat. 

    I kept adjusting the dome so the gasket was no longer catching too much heat, and it is all good. It is still off a little, but my gasket is ok. 

    Louisville, GA - 2 Large BGE's
  • My large is a little off but the seal is tight, If it doesn't leak, let it go. 
    Large BGE
    Sarasota, Fl.
Sign In or Register to comment.