Share your photos by tagging us and using the hashtag #BigGreenEgg.
Want to see how the EGG is made? Click to Watch
Temp problems
Comments
-
"How many minutes do you all wait after each vent adjustment before you declare the egg stable?"
For some folks here, the answer to that question is "60". I'm not that patient but you should know that some are.
I think the only mistake you made was trying to be too specific on your temp. With a little time you will learn APPROXIMATELY what settings will get you APPROXIMATELY what temps and you will get comfortable with it. For example, I know that if my bottom vent is open about 1/4 inch and the daisy wheel is set so that each of the 5 openings is barely open, my XL will settle in at a temp somewhere between 220 and 250.
The difference between cooking at 225 and as high as 275 isn't really worth discussing as long as you have a way to monitor the temp of what you are cooking. When it reaches the desired temperature, take it off.
You will probably still find yourself chasing temps from time to time. When that happens just stay close to the egg until you are happy with it. In that setting, the only excuse for leaving the egg is if you run out of beer. A fridge or cooler near the egg can solve that problem.
XXL BGE, Karebecue, Klose BYC, Chargiller Akorn Kamado, Weber Smokey Mountain, Grand Turbo gasser, Weber Smoky Joe, and the wheelbarrow that my grandfather used to cook steaks from his cattle
San Antonio, TX
-
Man im new to this whole egg thing too. The T-rex is the way to go. I put my cast iron grate on the fire box ( which expanded during heating and i could not move it ). Seared the steaks 60 seconds a side. Rested for 20 minutes. Put the steaks back in a raised grate for 10 minutes at 400. too rare for the wife so it went on another 10 minutesSt. Johns County, Florida
-
Fill the firebox to the bottom of the fire ring, no daisy wheel, bottom vent fully open - light the lump from the top, towards the front. I use an electric starter, but a torch or cubes or paper towels soaked in veggie oil works too. Once the lump starts to burn, maybe 10 minutes or so, close the dome, put on the DFMT and open the daisy petals completely, close the bottom vent to about 1/2. Go away for at least 10 minutes. Come back, drop in your set-up and adjust the vents as required. I think the biggest issue you are having is starting from the bottom. If you light from the bottom there is a very good chance you will consume all your smoke wood before you even start to cook. The egg is meant to be lit from the top of the lump pile.Delta B.C. - Whiskey and steak, because no good story ever started with someone having a salad!
-
MaC122 said:I put my cast iron grate on the fire box ( which expanded during heating and i could not move it )
I would be careful about doing that, If it expands enough it could possibly crack your eggCleveland, TN.
LG BGE, PSWOO2, Stoker WIFI.
-
MaC122 said:I put my cast iron grate on the fire box ( which expanded during heating and i could not move it ).
-SMITTY
from SANTA CLARA, CA
-
Thanks for all the help, everyone. I had been lighting from the top, but had some temp problems that way too. Maybe I'll give that a try again though and see what happens. Also, I have used the T. Rex method, which I think is incredible. Just figured I'd try the reverse sear too. Between the two, I think T. Rex might be the winner (at least for me).Southern California
-
I use an electric starter, too. Let it go 7 or 8 minutes. Then close the dome with daisy off and bottom vent wide open. I let it hit my target temp and then start adjusting.
Little Rock, AR
-
SMITTYtheSMOKER said:MaC122 said:I put my cast iron grate on the fire box ( which expanded during heating and i could not move it ).It is so much easier to just fill the egg with lump up to the top of the fire ring, more fuel, more heat, grid on top of the fire ring, easier to reach into and it will not put pressure on the base.Delta B.C. - Whiskey and steak, because no good story ever started with someone having a salad!
-
Just to change things up-when it comes to lighting the BGE, I light at the bottom (use about 1/4 starter cube (low&slow) or two for hot&fast). I light slightly forward of dead center, then build up the lump where lit to the remainder of the lump load. Run with bottom vent open and dome open around 6-10 mins, til I see about a grapefruit sized amount of lump burning (low&slow), then load up platesetter, cooking grate, drip pan, shut dome and set bottom vent to around 1/2" open. As temp passes 200*f, set DFMT and throttle lower vent to ease into the target cook dome temp.
For hot&fast-besides lighting in a couple of spots I wait til a good amoubnt of lump is burning before shutting dome and setting lower vent and DFMT.
As you can see from all the posts-as long as you have adequate fuel and air supply you can get where you want to go. Eggsperiment and have fun.
Louisville; Rolling smoke in the neighbourhood. # 38 for the win. Life is too short for light/lite beer! Seems I'm livin in a transitional period. -
lousubcap said:
Just to change things up-when it comes to lighting the BGE, I light at the bottom (use about 1/4 starter cube (low&slow) or two for hot&fast). I light slightly forward of dead center, then build up the lump where lit to the remainder of the lump load. Run with bottom vent open and dome open around 6-10 mins, til I see about a grapefruit sized amount of lump burning (low&slow), then load up platesetter, cooking grate, drip pan, shut dome and set bottom vent to around 1/2" open. As temp passes 200*f, set DFMT and throttle lower vent to ease into the target cook dome temp.
For hot&fast-besides lighting in a couple of spots I wait til a good amoubnt of lump is burning before shutting dome and setting lower vent and DFMT.
As you can see from all the posts-as long as you have adequate fuel and air supply you can get where you want to go. Eggsperiment and have fun.
Southern California -
@bicktrav-the small quantity is when I'm cooking low&slow (240-280*F range). When I put on the DFMT I start with the petals open and the shutter open around 1/4" or so, then adjust to get where the BGE steadies out. I initally see a temperature drop when loading all the interior pieces but as the ceramics warm up it will all warm back up. As you change air-flow thru the BGE it will have an impact on the fire volume and the dome temperature. I would just work with your vents and try not to be in a hurry when lighting-at least for the long duration cooks. FWIW-Louisville; Rolling smoke in the neighbourhood. # 38 for the win. Life is too short for light/lite beer! Seems I'm livin in a transitional period.
Categories
- All Categories
- 182.7K EggHead Forum
- 15.7K Forum List
- 459 EGGtoberfest
- 1.9K Forum Feedback
- 10.3K Off Topic
- 2.2K EGG Table Forum
- 1 Rules & Disclaimer
- 9K Cookbook
- 12 Valentines Day
- 91 Holiday Recipes
- 223 Appetizers
- 516 Baking
- 2.4K Beef
- 88 Desserts
- 163 Lamb
- 2.4K Pork
- 1.5K Poultry
- 30 Salads and Dressings
- 320 Sauces, Rubs, Marinades
- 543 Seafood
- 175 Sides
- 121 Soups, Stews, Chilis
- 35 Vegetarian
- 100 Vegetables
- 313 Health
- 293 Weight Loss Forum