Big Green Egg - EGGhead Forum - The Ultimate Cooking Experience...
We hope you had a hoppy Easter and are ready to spring into warm weather cooking mode! There’s nothing better than spending time outdoors with the sweet aroma of fresh cooked Ribs. Baseball season is also underway, so it's the perfect time to try out some chicken wing variations! We have Jamaican Jerk, Lemon Pepper, Fired-Up Wings and even a Whiskey Onion and Chicken Steak if wings aren't your thing. Bon appetit!



Big Green Egg headquarters has moved - come visit our new showroom and check out the museum and culinary center too! 3786 DeKalb Technology Parkway, Atlanta, GA 30340

Newbie - Finish question

I'm new to the forum and to the world of egging, but recently decided to dive in head first. I have an XL egg on the way, and a table from cypress table from JS Designs (after hearing about them from the board).   I've been trolling around the forum for a while to get info and answers to questions, but now I'm stuck.  I've decided to stain the table and am 90% sure I'm going the route of Australian Timber Oil.  On the can, and everyone at the stores has instructed to only put ONE COAT of the stuff on, but from reading through forum it sounds as though multiple coats is pretty common.  

Can anyone comment on their experience with the stuff, and provide any direction here?  Your advice is greatly appreciated.  

 


 

·

Comments

  • RACRAC Posts: 1,314
    Can help with the table but welcome aboard! I'm sure someone will help you in a few.

    Ricky

    Spring, TX

    ·
  • Thanks RAC.  I decided to finish the table with Watco's Danish Oil in Black Walnut, then topped it off with a few coats of Epifanes, with a final two coats of Epifanes Woodfinish Matte product.  It was a ton of work for someone with little finishing experience, but I couldn't be happier with the how it turned out.  I'll post pictures this weekend.  
    ·
Sign In or Register to comment.