Big Green Egg - EGGhead Forum - The Ultimate Cooking Experience...
Welcome to the EGGhead Forum - a great place to visit and packed with tips and EGGspert advice! You can also join the conversation and get more information and amazing kamado recipes by following Big Green Egg at:

Facebook  |  Twitter  |  Instagram  |  Pinterest  |  Youtube  |  Vimeo
Share your photos by tagging us and using the hashtag #EGGhead4Life.

In Atlanta? Come visit Big Green Egg headquarters, including our retail showroom, the History of the EGG Museum and Culinary Center!  3786 DeKalb Technology Parkway, Atlanta, GA 30340.

Clean Burn Questions! Need info!

Does anyone have any before and after pictures?
Does this hurt your gasket?
What is the purpose other than making it white again?
Do you just take top off and open bottom wide open?  Leave guts inside?
How long do you burn?  How often should you do this?



  • gdenbygdenby Posts: 5,833
    edited April 2013
    No pics from me.

    The old style gaskets can and will be trashed sooner or later. Hi-temp fires always are a hazard for them.

    It won't turn the whole inside white. The fire box and fire ring, yes. After many lo-n-slo cooks, the inside of the Egg is coated with a greasy, smoke permeated soot. Often, there is creosote build-up near the top vent. The clean burn reduces the film to just soot, which can easily be removed w. wadded up foil. This reduces carry over and excess smoke flavors. The cleaned interior also improves air flow slightly.

    Yup, top off, bottom open. I've done it w. the standard grill in, and the daisy wheel on it, so as to reduce build up on them to crust. But usually grill out.

    I burn away about 1/3 - 1/2 fire bowl of used lump. Typically, at the end of a long cook. Takes 1/2 - 3/4 hour.

    I do it if I notice a heavy smoke aroma any time I open the dome before I even start a fire. Or, notice flecks of creosote dropping onto foods. As mentioned above, I did a long series of low temp cooks, and after about 2 months, the inside of that Egg was glistening from grease build-up.
  • Charlie tunaCharlie tuna Posts: 2,191
    I have never purposely done a "clean burn", but mine gets cleaned when i do pizza!  :((
  • I did one right before I sold my large.  You can depend on toasting the gasket.  After the clean burn, the remains of my gasket were super simple to remove with a putty knofe.  The new self-adhesive high heat gasket from BGE was a breeze to install.  I had to re-align my dome for the added gasket thickness, but that was simple enough too.  Happy Egging!
    Flint, Michigan
  • I just recently did one and it did not get very white\ clean other than the firebox. I had a half load of lump, opened the bottom, removed the daisy wheel and let it go for two or three hours. 

    <?xml:namespace prefix = o ns = "urn:schemas-microsoft-com:office:office" /> 

    Don't do this unless you want a project that will put your egg of the DL for a few days.  The result was a melted gasket where I could not open the egg so I would recommend a short hi temp clean burn of and hour of less. 


    The upside is I'm installing the hi temp BGE gasket this morning to see how it will perform.

  • lousubcaplousubcap Posts: 16,211

    Remove your dome thermo before the burn-that way you won't wrap it around the dial.

    Louisville;  L & S BGEs, PBC, Lang 36; Burnin' wood in the neighbourhood. # 38 for the win.  Life is too short for light/lite beer.  
  • lousubcap said:

    Remove your dome thermo before the burn-that way you won't wrap it around the dial.

    :))   I learned that the hard way, ruined a thermometer.

    Welcome to the Swamp.....GO GATORS!!!!
  • dbCooperdbCooper Posts: 70
    My suggestions:
    If you have the old style ceramic coated grid take it out during the high temp burn.  New style SS grid can be left in.  Don't put the DFMT inside the egg.

  • njlnjl Posts: 871
    I was going to say remove the thermometer...but that's already been covered.  I don't even bother with the spring clip on mine...I like it to be easy in/out anytime I want it out.

    When I contacted BGE support about this years ago, the advice for a clean burn was load it up with lump, open top/bottom vents completely, light it, and let it burn until it burns itself out.

    At least with the older style gaskets, this will ruin the gasket...but it will also reduce anything non-metallic/non-ceramic in the egg to white ash dust.
  • SkiddymarkerSkiddymarker Posts: 8,299
    Used to do a clean burn every month or so but no longer bother. After a pizza cook, and the egg has cooled (next day) I rub the interior with a wad of foil or use a nylon brush and lots of crud just flakes off. Like @gdenby says, better to brush off the build-up on the dome rather than have it fall on your food. 

    Delta B.C. - Move over coffee, this is job for alcohol!
Sign In or Register to comment.
Click here for Forum Use Guidelines.