Big Green Egg - EGGhead Forum - The Ultimate Cooking Experience...
Welcome to the EGGhead Forum - a great place to visit and packed with tips and EGGspert advice! You can also join the conversation and get more information and amazing kamado recipes by following Big Green Egg at:

Facebook  |  Twitter  |  Instagram  |  Pinterest  |  Youtube  |  Vimeo
Share your photos by tagging us and using the hashtag #EGGhead4Life.

In Atlanta? Come visit Big Green Egg headquarters, including our retail showroom, the History of the EGG Museum and Culinary Center!  3786 DeKalb Technology Parkway, Atlanta, GA 30340.

New Rutland Installed, Fantastic Temp Control!

Just over 3 months into my novice egg'ing and my factory gasket failed, no surprise and no complaint.

Installed the Rutland gasket as suggested heavily here and I'm stoked!  After curing for an hour, I dumped in the remaining Royal Oak I had; barely half way up the firebox and have been maintaining 230 degrees with the draft door barely 1/4" open and the daisy wheel slightly open for hours.  I think I'm going to like all the benefits that comes with the new gasket!


  • Charlie tunaCharlie tuna Posts: 2,191
    I didn't know you could cook on it that soon?
  • gerhardkgerhardk Posts: 895
    A few carcinogen never hurt anyone, did they?

    Seriously he did not say he cooked  anything , just that he was maintaining a temperature.

  • Charlie tunaCharlie tuna Posts: 2,191
    I thought the adhiesive had to rest for 24 hours?
  • MrCookingNurseMrCookingNurse Posts: 4,393

    I thought the adhiesive had to rest for 24 hours?

    He might be using the temp to set the gasket. But I would assume a good 24 hours wouldn't hurt it.


  • I did use the copper high temp silicone and no, I didn't cook anything, just a low temp burn which held for 12 hours.
  • Charlie tunaCharlie tuna Posts: 2,191
    The biggest advantage I noticed was my reduced amount of lump. I was burning up a lot of lump after closing the top and bottom vents after my cooks!
Sign In or Register to comment.
Click here for Forum Use Guidelines.