Big Green Egg - EGGhead Forum - The Ultimate Cooking Experience...
As we round out National BBQ Month, we hope you’ve gotten to try some new recipes that will keep you cooking all summer long. Check out our Smoking Basics Publication. For delicious recipes, try Justin Moore’s BBQ Shrimp, Greg Bate’s BBQ Dr. Pepper Chicken, Bobby Flay’s Chicken Thighs or Dr. BBQ’s new Maple Brined Pork Chops. Need dessert? Finish off your meal with some Planked Twinkies. Get ready for some fun summer happenings!

Big Green Egg headquarters has moved - come visit our new showroom and check out the museum and culinary center too! 3786 DeKalb Technology Parkway, Atlanta, GA 30340

New Gasket - Lots of overhang...

So I just installed a new gasket. I ordered it from Fred's Music & BBQ. I did the pre-shrink in the dryer. Bought the 77 spray...

After I started applying I realized the gasket quite wide and there's lot of overhang on the outside of the egg. Is that OK? There's no overhang inside.

Just curious

Is it supposed to be wide? 
Should I cut the outside overhang?
·

Comments

  • lousubcaplousubcap Posts: 6,236
    Not sure how much overhang you have-not a problem from the seal and as long as no overhang on the inside it won't affect gasket life.  Depending on the amount outside if you leave the BGE uncovered it could be a source of moisture into the BGE but it would take lots of rain/snow and a good period of lack of use for that to develop into an issue.  Just an opinion and we all know what those are worth-
    Louisville
    ·
  • canadianehcanadianeh Posts: 32
    edited March 2013
    I'd say around 3/16th's of an inch and quarter-inch at the most.

    Zero overhang inside.
    ·
  • lousubcaplousubcap Posts: 6,236
    First time I've heard of that much-and it's the entire circumference...I was going to ask if your dome is aligned but if you have that much all the way around then that's not the cause. Personally I doubt it would become a problem but it should be easy enough to trim down to help with the asthetics...FWIW-perhaps others will be along.
    Louisville
    ·
  • It's top and bottom. I've got perfect alignment - the top lid is off right now.

    I wonder if I was sent a gasket for an extra large in large packaging.

    I can trim it with my shun knives.

    ·
  • lousubcaplousubcap Posts: 6,236
    I thought of that possibility but you would have a whole lot of extra gasket material (length-wise) if that was the case.  You may want to give Fred's a call and see if this has been an issue for them in the recent past.
    Louisville
    ·
  • canadianehcanadianeh Posts: 32
    edited March 2013
    True. Only a couple extra inches length wise.
    I guess I'll try trimming it.
    ·
  • ChubbsChubbs Posts: 5,112
    Do you have pics? I would call Fred back and ask him about it. None of my replacements had overhand.
    Columbia, SC --- LBGE 2011 -- MINI BGE 2013
    ·
Sign In or Register to comment.