Big Green Egg - EGGhead Forum - The Ultimate Cooking Experience...
It feels as though we’ve waited forever for college football to start, and finally the wait is over! Check out our tailgating page for recipes that are sure to become fan favorites. As an added bonus, the day before Labor Day is National Bacon Day and we don’t know about you, but we like putting bacon on anything and everything, so we’ll definitely be celebrating that. It's time to think about getting out to one of the many #EGGfests around the country - see a list here

Daisy wheel and high temp fire grate

Good afternoon Eggers I have a couple of ??? Dropped my daisy wheel and cast iron loops broke off so the spring loaded handle will not reattach, daisy wheel still works fine, any advice on who to go to for replacement or not worry about it? Secondly, anybody used the stainless high temp fire grate, if so,please share your experience. Thanks and have a great weekend Culdesacera

Comments

  • High-Que fire grate in MBGE, works very well for low and slow, not a huge difference noted in the high temp cooks. With the OEM cast grate on low temp cooks, I had a wiggle rod, where you reach in through the lower vent and "shake" the coals to keep it going with even temps. Since using the High-Que, do not need the wiggle rod. Some say they use more charcoal, but is not my observation.

    The DFMT can be purchased if you have $30 burning a hole in your pocket, else I'd not worry about. Maybe use something (oven mitts?) to get it off and drop on the ceramic cap when snuffing the egg. 
    Delta B.C. - Vee-Gan: old Indian word for poor hunter. 
  • EggcelsiorEggcelsior Posts: 8,540
    You can buy a replacement, but I wouldn't worry about it. I presume you are talking about the "handle" for the daisy wheel that allows you to pick it up. The only issue would be it getting to hot to grab, say, if you want to shut down the egg by putting the rain cap on. Just use a oven mitt or grill glove for this.

    I have the High-Cue grate and I love it. I had issues with the original grate and fires going out on low-and-slows from too much ash build up. This was the lumps fault, but I wanted something that would be able to compensate for it. It gets up to temp very quickly, which is really nice. For me, the only downside is that it doesn't "seat" on the fire box like the CI one does, so I have to be careful when stirring old lump. Otherwise, it slides up if bumped and lump can fall down. This does not happen very often(only twice since I got it last summer), but it is a possibility.
  • Solson005Solson005 Posts: 1,841
    I bought a High-que for my small egg when I first got. Everyone says it works great for the smaller eggs and I haven't even used the stock one on the small to compare the two, it does get up to temp quickly but is also smaller than the large. I thought about getting one for my large but haven't had any issues so I never did. If you take off your daisy wheel often I would get a new one if not I probably wouldn't worry about it. 
    Large & Small BGE, CGW Two-Tier Swing Rack for BOTH EGGS, Spider for the Wok, eggCARTen & and Cedar Pergola my Eggs call home in Edmond, OK. 
  • MickeyMickey Posts: 14,024
    edited February 2013
    You don't  have to use it. I don't use it. Lots don't use it. No worries..... Have High-Que in both Larges and in the Mini...
    Salado TX Egg Family: 2 Large and a very well used Mini.... 5th Salado EggFest is March 14, 2015

  • jlsmjlsm Posts: 728
    Huge High-Que fan here. Had trouble with ash buildup on the mini before I got it; now I rarely take the whole egg apart to clean. Last night we were ready to cook at 500 on the mini about 15 minutes after I lit it; I could never get such a quick reaction with the standard grate. I have it on the large, too, and I like it there as well, but it makes an enormous difference on the smaller eggs.  
    *******
    Owner of a large and a beloved mini in Philadelphia
  • My handle fell off. Somehow got loose. I just bent it back enough to make it hold. Al good now


    _______________________________________________

    LBGE & SBGE (big momma and pat)
  • Just make a new one out of a coat hanger!! ;))
  • johnkitchensjohnkitchens Posts: 1,131
    edited February 2013
    Sorry. I tried to cancel this post, but it will not let me.
    image
    Louisville, GA - 2 Large BGE's
  • Thanks to all for your help, I'm going to bypass the daisy wheel and use the $$$ to buy a new fire grate....will report back Have a great weekend and thanks again Culdesacer
  • I dropped mine and broke the loops also....I got some JB Weld reattached the loops put the handle back on and its just like new. get you some JB Weld and you will be set.
    Brandon, MS
Sign In or Register to comment.