Big Green Egg - EGGhead Forum - The Ultimate Cooking Experience...
We hope everyone enjoyed their Fourth of July weekend and is excited for more warm weather grilling! This week, we’ll be making these two burgers: Stuffed Portobello Mushroom and Caribbean Chicken, and also eating lots of these Ice Cream Sandwiches in honor of National Ice Cream Month! It's time to think about getting out to one of the many #EGGfests around the country - see a list here

Space between egg and table top

grillingunnergrillingunner Posts: 69
edited July 2012 in EGG Table Forum
I just got done building my table for my large egg. According to the BGE website plans I cut my hole 21". I have about 1/4" clearance between the egg and wood all the way around. Is this enough clearance?

Comments

  • misumisu Posts: 212
    Depends how well centered you keep the egg. Next time you do a clean burn or some hot pizza and you see smoke you may have to adjust. And it's lovely to try to move a red hot egg even half an inch, don't ask me how I know all this :)
  • MayberryMayberry Posts: 421
    I cut mine to 21 inches exactly, and had the same concerns. I took my orbital sander around the hole a few times to take a little more off and got it closer to 1/2" gap all the way around. It also smoothed out the top edge, which was a plus. Hope this helps.
    Athens, GA
  • ETBeeETBee Posts: 38
    You could put a concrete paver (or a second one if you already have one) under the egg.  That would raise it a couple of inches and due to the tapered shape of the egg, give you a little more clearance in the table opening.
  • I called BGE and they informed me that I have plenty of clearance between my egg and table. Now if UPS would just get here wih my clinch studs since I broke one while assembling my egg I can finally use my egg.
  • McStewMcStew Posts: 199
    sorry ahead of time for the rushed pic 

    for the large I cut the holes on all the tables i make at 22 inches 
    I had the same problem as misu with one table top the was smoldering because we were doing pizzas for five hours at 700 welding gloves come in handy 

    picture is a L with 22 inch hole

    if you have any hesitation just add another brick 

    photo-60.jpg
    640 x 478 - 124K
    Marina Del Rey CA 
  • twlangantwlangan Posts: 285
    That is the size of the hole I made in my table. Since mine is a cheapie, pine lumber, and painted, I only once noticed a bubble in the paint in one spot while cooking a pizza. Never has occurred again. I put my feet between my Egg and fire brick base which raised it a bit and gave me about 1/2" all the way around.
  • nolaeggheadnolaegghead Posts: 10,758
    If your wood top around the inside of the hole is smoldering (presumably because you're doing pizza at 700 plus degrees), you can run a fan aimed at the bottom of the egg, or coat the inside of the hole with epoxy.  My top is epoxied and, while it gets hotter than hell, no smoldering or discoloration.  The bottom shelf isn't covered, and while it probably gets even hotter, I did get some discoloration in the finish.  I've since put a thicker brick under the BGE, and used the little green feet between the brick and egg.
    ______________________________________________
    This is my signature line just so you're not confused.
    Large and Medium BGE, two turntables and a microphone, my friend.
    No City.

  • McStewMcStew Posts: 199
     the table that was smoldering was built 10 years ago out of raw pine ... it can happen i wish i had to pics for you
    Marina Del Rey CA 
Sign In or Register to comment.