Big Green Egg - EGGhead Forum - The Ultimate Cooking Experience...
It doesn’t get much hotter than the EGG cookin’ in July! Make sure to keep yourself hydrated with a bit of whatever you’re using for the Beer Can Chicken. Ice Cream Sandwiches are also a great way to stay cool. Looking for some great ideas for a summer cook out? Try out a Pimento Cheeseburger or Dr. BBQ’s Spare Rib Surprise. Just don’t be surprised if your neighbors stop by for a quick bite when they smell what you’re cooking!

Big Green Egg headquarters has moved - come visit our new showroom and check out the museum and culinary center too! 3786 DeKalb Technology Parkway, Atlanta, GA 30340

Draft Door Question

Bubba12803Bubba12803 Posts: 24
edited June 2012 in EggHead Forum
I am still working on my BGE repair project and my ordered parts have come in, except the handle. My question is when I rescued the egg there was no draft door but the screws were still there and what appeared to be some sort of rubber that looks like it would run along the edges of the draft door. I have my new draft door to install but it did not come with any type of rubber seal. Is there something that I am missing or is there some type of sealer I should use behind the draft door?
·

Comments

  • KristinnnKristinnn Posts: 133
    My draft door just looks like it has silicone caulking along the edge.. I only noticed this because it seemed kinda messy looking
    ·
  • Bubba12803Bubba12803 Posts: 24
    Thanks. That must be what it is. I will have to put a bead around the door before I install it.
    ·
  • +1 on the silicone
    Conway, S.C.
    ·
  • EggdamEggdam Posts: 218
    Make sure it can take the heat.  Install the draft door then silicone the edges.  I would tape it off with painters tape myself to ensure you get a nice clean bead!
    ·
  • Bubba12803Bubba12803 Posts: 24
    Make sure it can take the heat.  Install the draft door then silicone the edges.  I would tape it off with painters tape myself to ensure you get a nice clean bead!



    Thanks!
    ·
  • uncledaveuncledave Posts: 87
    I would check with the mother ship to see what type sealant they use. I don't think silicone would take the heat.
    ·
  • Bubba12803Bubba12803 Posts: 24
    I would check with the mother ship to see what type sealant they use. I don't think silicone would take the heat.


    Good idea. I will email them today.
    ·
  • stikestike Posts: 15,597
    edited June 2012
    they use silicone....
    [edit: when replacing it though, some owners use high heat silicone on the BACK of the assembly, so that it is not visible, and it acts as an adhesive, especially if the bolt holes don't line up.  but the factory uses clear silicone, which is surprisingly not high-temp, though it does just fine.  ]
    ed egli avea del cul fatto trombetta -Dante
    ·
  • Bubba12803Bubba12803 Posts: 24
    Got an email back from the mother ship advising me that for best results I should apply high temp silicone to the top and bottom of the door. Thanks everyone for all the help and advice.
    ·
Sign In or Register to comment.