Share your photos by tagging us and using the hashtag #BigGreenEgg.
Want to see how the EGG is made? Click to Watch
Low and Slow Questions
Comments
-
I usually shoot for dome 250 degrees. To achieve this I use two starter cubes-- left and right center. My vents are set with daisy wheel closed with holes completely open and bottom vent open around an inch. Sometimes I adjust the vents a hair, but this is a good start for me.Columbia, SC --- LBGE 2011 -- MINI BGE 2013
-
Those questions are very hard to answer. It depends on what size egg you have and the condition of your gasket and many other things.When I do brisket, the top wheel thingy is closed with the wheel vents all the way open. The bottom vent is open the thickness of 3 quarters.I like to start the fire so only about half the lump is burning and then shut the vents to the settings stated above. Once again, the fire starters depend on lots of things but, I dont think it will be a deal breaker. Just throw 2 or 3 in there.Here's a tip: Let your egg stabilize for about 45 min if you are not familiar with temp control. If the temp stays put for 45 min, you are most likely good.Be careful, man! I've got a beverage here.
-
Sorry I left out the details. I have a LGE which I thoroughly cleaned, loaded with large pieces of coal on the bottom. The gasket is in good shape. I'm putting a 12 pound packer on it. Waiting for the UPS delivery guy to bring my Maverick 732, which should be here any minute.
-
After I light - an inch or two below the top level of the charcoal - I then wait 4 or 5 minutes, till I am seeing 2 or 3 inch flames and an area the size of a baseball that is starting to glow.
I close the lid, shut the bottom vent to 1/4 inch. I stay close by, if the fire falters, give it a bit more air, then go back with the vent settings. Typically the dome temp will get up around 270 to 290 - but never above. Cap is on now, open daisy wheel hole only.
Start squeezing the bottom vent down, closing a bit to bring the temp back down around 250.
I may watch the temp for an hour before I ever load plate setter and meat. I get to the point that I know the settings are correct for the temp I want, stable for a while. Then load everything up - hook up the maverick - I do not open the dome until I am approaching the 190 range on internal temp in the meat.
The temp will drop with the addition of the cold items - but when it comes back, it will come back to the level I had stabilized at.
This approach has worked for slow cooks for me. I think the stabilization time is a big factor.
Cookin in Texas -
Thanks for the feedback. I plan on starting it up about 11 tonight and hopefully have the brisket on by midnight. I will admit that I've lost patience with this delivery guy bringing my Maverick. I may end up doing this off the dome and my probe thermometer.
-
Well the delivery guy finally brought the Maverick.
-
I see that the dome temp should be around 250, but what about the grate temp?
-
the grate eventually stabilize to same temp as dome..
-
Well all systems are a go. The temp is slowly climbing back up. Fingers crossed that it turns out as planned. :-SS
-
Morning TX.
And?????????Bx - > NJ ->TX!!!All to get cheaper brisket! -
Currently at 154 with a grate temp of 226.
-
Take pictures of finished product!
-
160/226
-
FWIW I wouldn't use firelighters. There are plenty of other ways to get it going - do a search on here, which won't leave the lighter taste in your food
-
I will probably try the oiled paper towel method in the future. These are just paraffin and wood shaving starters. I've never noticed any unusual smell or taste in using them before. Plus, I let the egg stabilize for an hour before putting the brisket on, which probably would've eliminated any off-putting smell/flavor. I agree with you though, that there are better AND cheaper methods for starting a fire, but I had these on hand.
-
Is there a minimum resting time when it's finished? It's not finished but it'd be nice to eat sometime before midnight.
-
The Maverick ET732 alarm woke me up at 6 this morning to let me know that the egg temp dropped below 215. I managed to get a few hours sleep using the aforementioned remote thermometer.
Right now it's been on for 14 1/4 hrs. The temp is at 171 internal and 246 in the egg. I bumped the temp a few hours ago because I'm afraid it won't be ready by the time I'm ready. -
Yeah if I had one of those experiences I'd be nervous too. I don't know if you have a Maverick. I just got mine yesterday and it definitely has helped out with this cook.
-
you don't need to rest something that's been cooked to 200. only reason i let it rest is to give it time to cool a bit to the touch.
at mountaindewbass... if your fire went out at three, the meat still wouldn't be useless. but that's another discussion.
light the thing, get it stable. toss the food on at 11 or 12. if you are really paranoid, get up at 4. even if it went out the instant you'd turned your back, the meat would still be fine. check on it at 4. back to bed. up at 7 or 8. check again.
never more than four hours unattended.
ed egli avea del cul fatto trombetta -Dante -
That's the main reason that I love my BBQ Guru.....build a good fire, set the desired temp and go to bed not worried about a thing.
-
I got shocked for my birthday this past Monday. The wife surprised me w/ BBQ Guru digiq dx2. I cannot wait till tomorrow after work to get a brisket and butt going on the L-BGE. Six year BGE owner/cooker. I have always loved to grill and smoke. I still like to do cook on a big pit for large cooks but nothing beats the product from a BGE!
I know I didn't add anything to this discussion. I am just PUMPED to use the bbq guru. Some just don't understand our excitement.
I just wanted to share my excitement
Reed- Springhill, Louisiana -
Very cool forty. Hope you have great success with your latest addition! I was happy to get my Maverick as I didn't have to run in and out of the house every couple of hours. I still did, but the point is I didn't have to.
-
16 hours and now up to 176. Geez my stomach is growling.
-
the reason i wanted to get my BGE was so that i wouldn't have to tend to the fire...
the thing controls temps fine. it's usually the fire builder who has the issue. fires go out with the powered draft units too. just saying.
they are great, but you still need to build a stable fire
ed egli avea del cul fatto trombetta -Dante -
I'm concerned, but not too much. (I've had food poisoning, too, so it scares me ____less.) I'm a light enough sleeper that it is not hard for me to get up once in the middle of the night to go check. I've had a dead fire once, that I caught when the dome was still 150F. That was caused by a fire that burnt straight down. I had another that was fading, and had dropped to 180. I recovered both.for low and slow..anybody afraid that the lump will go out in the middle of the night? Thus far i have done all my low and slows starting early morning(4am) and i stay awake till its done..usually 12 hours later. So im curious on how you make sure the lump wont go out at 3 am..thus making the meat useless.
There have been many discussions about all of this. One of the things no one has any information about is how a piece of solid meat that has surely been in 250F temperature for several hours could become contaminated while sitting in an Egg. For safety's sake, everyone admits to the old saying "When in doubt, pitch it out." But I wish someone knew how to do a bacterial culture of something that baked in the Egg, and then just sat there for 6 - 8 hours.
Based on those 2 times, I go and check. At least 50% of the time, the dome is sitting at 250, right where I left it. Often enough, the temperature has slid a little either way. I caught one at 300, but it just meant the food was done a few hours earlier.
Recently, I have tried cooking hotter and faster for PP. The results were good. I had a 9 pound picnic that would have finished in about 6 hours. If the next one turns out as well, I'm likely to say good bye to over-nighters for pork.
-
"One of the things no one has any information about is how a piece of
solid meat that has surely been in 250F temperature for several hours
could become contaminated while sitting in an Egg."
i have asked this a million times, and all the experts shy away. have been asking it for a while now.
there is a massive difference (huge) between that PP sitting in your egg four hours after the fire died, and the same exact same hunk of PP sitting in a buffet line for four hours.
ed egli avea del cul fatto trombetta -Dante -
I used to live in a third world country for awhile where things aren't prepared at remotely near the same levels of concern for sanitation and food safety. One bout of amoebic dysentery is one bout too many. Regardless I lived to tell the tale. I think most of the time your safe unless you are feeding children, the elderly or those with compromised immune systems. Otherwise as long as the temps didn't fall off too much for too long you'd be fine.
-
for low and slow..anybody afraid that the lump will go out in the middle of the night? Thus far i have done all my low and slows starting early morning(4am) and i stay awake till its done..usually 12 hours later. So im curious on how you make sure the lump wont go out at 3 am..thus making the meat useless.
I may be suffering from PTSD a little. A while back i had made home made beef jerkey and put it in the dehydrator for 4 hours, when i came home the dehydrator was unplugged(wife unplugged it) the meat looked done, i took a bite..and it was NASTy...followed by food poisoning..so i may be a little over cautious
Keepin' It Weird in The ATX FBTX -
the reason i wanted to get my BGE was so that i wouldn't have to tend to the fire...
the thing controls temps fine. it's usually the fire builder who has the issue. fires go out with the powered draft units too. just saying.
they are great, but you still need to build a stable fireThough I wouldnt pretend to have the knowledge base that Stike has - the little bit of knowledge I do have says this so on target and correct. There is alot said in that succinct statement.
Well stated Stike.
Cookin in Texas -
for low and slow..anybody afraid that the lump will go out in the middle of the night? Thus far i have done all my low and slows starting early morning(4am) and i stay awake till its done..usually 12 hours later. So im curious on how you make sure the lump wont go out at 3 am..thus making the meat useless.
I may be suffering from PTSD a little. A while back i had made home made beef jerkey and put it in the dehydrator for 4 hours, when i came home the dehydrator was unplugged(wife unplugged it) the meat looked done, i took a bite..and it was NASTy...followed by food poisoning..so i may be a little over cautious
Keepin' It Weird in The ATX FBTX
Categories
- All Categories
- 182.7K EggHead Forum
- 15.7K Forum List
- 459 EGGtoberfest
- 1.9K Forum Feedback
- 10.3K Off Topic
- 2.2K EGG Table Forum
- 1 Rules & Disclaimer
- 9K Cookbook
- 12 Valentines Day
- 91 Holiday Recipes
- 223 Appetizers
- 516 Baking
- 2.4K Beef
- 88 Desserts
- 163 Lamb
- 2.4K Pork
- 1.5K Poultry
- 30 Salads and Dressings
- 320 Sauces, Rubs, Marinades
- 543 Seafood
- 175 Sides
- 121 Soups, Stews, Chilis
- 35 Vegetarian
- 100 Vegetables
- 313 Health
- 293 Weight Loss Forum