Will a digital "stay in" thermometer cord effect the seal

Greygoose · September 2011

I'm considering buying a meat thermometer that stays in the meat. it has a thin cord that attaches to a readout box outside the grill. I figure that i have two choices:

1. run the cord straight out through the seal into the readout

2. run the cord through the bottom vent

The first option is the most enticing since it seems to be the easiest.

the Second option would be tricky since i would need to keep the coals away from the wire since its probably not rated to withstand that hot of temps. it would also be a pain to set up each time.

Does anyone know if running the compressing the wire will somehow effect the seal between the top and the base? will it have an effect on how well the eggs top and bottom seal (allowing moisture and heat to out).?

thanx

Greygoose

Spoon · September 2011

I run my wire through the seal and have no problems with the seal. I think you would end up frying your probe if your try to run it through the bottom vent, even the high temp probes are only rated to 700.

4Runner · September 2011

Just run it out of the Egg and then close your lid on it. It will be just fine.

Shwiezzee · September 2011

Don't over think things, Put the probe in the meat and close the lid. If you are running temp probe also, put that on grid not up on the Vrack! and Bob's your uncle!

Will a digital "stay in" thermometer cord effect the seal

Comments

Categories