Welcome to the EGGhead Forum - a great place to visit and packed with tips and EGGspert advice! You can also join the conversation and get more information and amazing kamado recipes by following Big Green Egg to Experience our World of Flavor™ at:
Want to see how the EGG is made? Click to Watch
Facebook | Twitter | Instagram | Pinterest | Youtube | Vimeo
Share your photos by tagging us and using the hashtag #BigGreenEgg.
Share your photos by tagging us and using the hashtag #BigGreenEgg.
Want to see how the EGG is made? Click to Watch
Where Did I Go Wrong ???
Options
Grillin&Chillin
Posts: 31
Last night I cooked some rib eyes that didn't turn out well. I know, how do you screw up steaks?
I started with a 550 degree dome. I put 6 boneless rib eyes on my large BGE. They nearly covered the cooking surface. Bottom vent was wide open and top vent nearly so. I cooked 4 minutes, opened and turned. Cooked another 3 minutes and removed. When the top was opened there was a lot of flames from fat burning off. Other than to flip and remove, I didn't open the top during the cook.
Now for the problem - all the steaks had that "flamed fat" taste to them. I'm not sure how else to describe it. I experienced it more when cooking fatty foods on my old gas grill. All the steaks looked fine - nice, even char on the outside and medium rare inside.
All comments/suggestions are welcome.
I started with a 550 degree dome. I put 6 boneless rib eyes on my large BGE. They nearly covered the cooking surface. Bottom vent was wide open and top vent nearly so. I cooked 4 minutes, opened and turned. Cooked another 3 minutes and removed. When the top was opened there was a lot of flames from fat burning off. Other than to flip and remove, I didn't open the top during the cook.
Now for the problem - all the steaks had that "flamed fat" taste to them. I'm not sure how else to describe it. I experienced it more when cooking fatty foods on my old gas grill. All the steaks looked fine - nice, even char on the outside and medium rare inside.
All comments/suggestions are welcome.
Comments
-
Was your smoke clear before putting on the steaks? How long did you let the fire burn before cooking?
-
You may want to try the reverse sear method, starting at lower temp, and finishing high.
-
You may want to try the reverse sear method, starting at lower temp, and finishing high.
-
it might have just been to much fat with that many steaks... i have done that with chix thighs direct and had that same taste. maybe two batches are in order with that many...
-
Flame is the enemy, heat is good!
I sear on both sides, as you did. remove, add Plate Setter + drip pan with water. Wait for 350/400 and add steak to finish.Dave
Cambridge, Ontario - CanadaLarge (2010), Mini Max (2015), Large garden pot (2018) -
you'll need to trim most of the fat if doing that many ribeyes, including that fat socket. Or cook them at lower temps. I learned trimming the fat after one of my first blackening cook, see pic below. thought for sure one of the neighbors was going to call the fire departement.
www.ceramicgrillstore.com ACGP, Inc. -
I use this method, hot as you can get 600-700 sear 2 min, flip 2 more min, close all vents flip and roast for 2-3 min. depending on thickness.I let them get to 130 inside and serve. I like mine med. rare. Works every time. I think you got a lot of flame due to the vents bieng open.
-
I always sear mine at 500+ with the lid OPEN you need all the oxigen to have a proper combustion & sear. You will see lots of flames dont't worry they won't burn leave them for 90 to 120 seconds/side pull and close lid & vents completely. Wait for the dome temp to come down to 380 or so & stabilize. Put ribeyes back close lid & pull at desired internal temp I like mine at 135.
-
winemaker ron wrote:I use this method, hot as you can get 600-700 sear 2 min, flip 2 more min, close all vents flip and roast for 2-3 min. depending on thickness.I let them get to 130 inside and serve. I like mine med. rare. Works every time. I think you got a lot of flame due to the vents bieng open.
I do it basically like this as well and get great results every time. Perhaps that 4 minutes on one side was a bit long.
I've cooked many steaks with flames up and tickling my meat and still get great results. I don't mind a bit of flame personally, but wouldn't want that for 4 minutes straight. Sometimes I'll close the top vent a bit to kill off flames that are too much if I have alot of fat dripping. Could be from adding some bacon to the grill with the steaks. Mmm bacon. -
How about those who 'T-Rex' their steaks diretly on the lump? Doesn't this create an infernal, fat-burning scenario or does it just get vulcanized?? Can anyone 'splain this? Thanks~~!
Categories
- All Categories
- 182.7K EggHead Forum
- 15.7K Forum List
- 459 EGGtoberfest
- 1.9K Forum Feedback
- 10.3K Off Topic
- 2.2K EGG Table Forum
- 1 Rules & Disclaimer
- 9K Cookbook
- 12 Valentines Day
- 91 Holiday Recipes
- 223 Appetizers
- 516 Baking
- 2.4K Beef
- 88 Desserts
- 163 Lamb
- 2.4K Pork
- 1.5K Poultry
- 30 Salads and Dressings
- 320 Sauces, Rubs, Marinades
- 543 Seafood
- 175 Sides
- 121 Soups, Stews, Chilis
- 35 Vegetarian
- 100 Vegetables
- 313 Health
- 293 Weight Loss Forum