Broken platesetter

texasfiddlefan · December 2010

I set my hot platesetter down a little to hard and broke a leg off. It's a clean break. What can I use to repair it?

Thanks in advance

Carolina Q · December 2010

everyone seems to love JB Weld. any hardware or auto parts store should have it.

Fidel · December 2010

less testosterone

or JB Weld.

stevesails · December 2010

i hear JB weld is always good, you should have some in yout toolbox anyway, but it may be the best way to fix it is with a visa or mastercard.

FlaPoolman · December 2010

Like the others said,,,JB weld

LoveHandles · December 2010

After the JB weld,I drill 1/8" holes around the repair with a ceramic drill bit and then run wire from hole to hole like lacing a shoe up. Always worked great for me

texasfiddlefan · December 2010

It sounds like JB weld is the way to go.
What kind of wire do you use?

Little Steven · December 2010

Uh,

Mr. Poolman, I broke a platesetter jut that way. I have since lost the broken off bit. Do yo think I could fashion a complete legg from JB Weld? Thanks in advance for your expert opinion.

Steve

FlaPoolman · December 2010

Let me think about that,,,,,,

Nah, that's a crappy idea :laugh:

Little Steven · December 2010

Mr. Poolman,

I don't take any offense to you calling my idea crappy but you should know that that Water Closet is not connected to any plumbing.
That was frikkin hilarious.

Steve

FlaPoolman · December 2010

and never will be again :huh: I had to buy a new one today along with everything else

I told the wife that should have been our Christmas card this year :laugh:

LDD · December 2010

FlaPoolman wrote:

Let me think about that,,,,,,

Nah, that's a crappy idea :laugh:

LMAO :woohoo: this has had me in stiches for the past 2 min.

QBH · December 2010

Keep in mind that JB weld is only rated to 500 degrees. It shouldn't be a problem unless you are doing pizzas.

LoveHandles · December 2010

Just plain old bailing wire

Broken platesetter

Comments

Categories