Big Green Egg - EGGhead Forum - The Ultimate Cooking Experience...
Are you happy it’s finally National BBQ Month? While we like to BBQ year round, May is our favorite because the whole country is celebrating delicious food. If you’re new to cooking BBQ on your EGG, check out our Smoking Basics Publication...if not, proceed to some of our favorite recipes! We love Dr. BBQ’s Coffee Rubbed Brisket, Famous Dave’s Sticky Ribs and Virginia Willis’ Pulled Pork. Pair with this cheesy favorite for a winning way to start off May!

Big Green Egg headquarters has moved - come visit our new showroom and check out the museum and culinary center too! 3786 DeKalb Technology Parkway, Atlanta, GA 30340

Bottom vent won't slide well

TomCPATomCPA Posts: 82
edited 2:23AM in EggHead Forum
Hello all,

My new medium BGE, which I picked up at Waldorf Eggfest, is having a small problem. The bottom vent seems to be sticking. It takes a lot of force to slide open and when it does, it slides the other the screen with it as well.

I used WD-40 figuring that would free it up, but no luck. Any ideas on how to free the bottom vent?

Thanks,

Tom
·

Comments

  • RRPRRP Posts: 15,045
    Sounds slightly bent. Simply take a slotted screwdriver and bend the track wherever it is pinching.
    Ron
    Dunlap, IL
    ·
  • egretegret Posts: 4,030
    Sounds like your doors are reversed. The screen should be on the inside....solid on the outside.
    image
    ·
  • RRPRRP Posts: 15,045
    could be John, but my screen is on the inside and yet I must hold the screen tab with my left thumb while I open the slider with my right. It just sounds like his got bent. My excuse is I retrofitted mine to accept the screen. :)
    Ron
    Dunlap, IL
    ·
  • egretegret Posts: 4,030
    I have two retrofits and experience the same thing you do. I mean, trying to get two doors to slide in a slot designed for one will cause problems. I also have three with the new door design and there is plenty of 'slop' for the doors.....almost too much. Not saying he doesn't have a track problem as you pointed out.....I'm saying the newer versions are so loosy-goosy the most likely cause is the doors being reversed. It would be nice if the original poster reported back..... :ohmy:
    image
    ·
  • TomCPATomCPA Posts: 82
    Hey guys,

    Out all day visiting clients. I was too tired to answer until this morning. Thanks for the feedback.

    The doors are not reversed. I did put a slotted screwdriver in the track this morning and did loosen the slides a bit, but they still stick together and I have to slide the screen back to its position.

    Any more thoughts are greatly appreciated.

    Tom
    ·
  • Bob VBob V Posts: 195
    Tom -

    I had the same problem with my medium when I retrofitted the screen. Here are the two things I ded:

    a. Don't use a screwdriver to open the track up (you'll get uneven marks). Take out both doors and use the solid door as the pry bar on a one of the tracks. It will fit perfectly, of course, but use it to bend the track outward. Then do the other track. You may have to do it a couple of times and test until you get it right.

    b. This may be obvious, but wasn't immediately to me. Put the screen in first with the tab end first, so it matches up to the frame's tab, then *reverse* the solid door do that the tab goes in last. That way you are not trying to move both doors at the same time, and it is better on your fingers if you slip.

    Bob V
    ·
Sign In or Register to comment.