Big Green Egg - EGGhead Forum - The Ultimate Cooking Experience...
We’re halfway through National Barbecue Month and loving every minute of it. We hope you’ve had some time to try out some new recipes and enjoy a few old favorites as well. If you’d a couple tips on smoking meat, check out our Smoking Basics Publication. For delicious recipes, try Justin Moore’s BBQ Shrimp, Greg Bate’s BBQ Dr. Pepper Chicken, Bobby Flay’s Chicken Thighs or Dr. BBQ’s new Maple Brined Pork Chops. Need dessert? Finish off your meal with some Planked Twinkies. Have a great rest of May & get ready for some fun summer happenings!

Big Green Egg headquarters has moved - come visit our new showroom and check out the museum and culinary center too! 3786 DeKalb Technology Parkway, Atlanta, GA 30340

3M wire brush used for gasket prep

I saw on one of the many gasket posts, where someone posted a picture of a wire 3M brush that works as an attachment to a drill.  I searched several of the gasket posts but couldn't find the picture that I was looking for.

If that poster or someone else could post it, I would really appreciate.  I have a friend who works at 3M and they have a company store.  He is replacing my gasket also, so he can buy the brush at a big discount.

TIA
·

Comments

  • BOWHUNRBOWHUNR Posts: 1,442
    This is the one you want.  I've used one to install Rutland's on all four of my eggs.  The small's factory gasket finally gave up and I just replaced it last night.

    Mike

    image

    I'm ashamed what I did for a Klondike Bar!!

    Omaha, NE
    ·
  • Hungry JoeHungry Joe Posts: 1,148
    FWIW the last time I replaced my gasket I did it while the egg was still warm and 95% of the gunk came off with a scrapper with almost no effort. I just gave it a quick brush after scraping  then some acetone and I was good to go.
    ·
  • tazcrashtazcrash Posts: 1,851
    +1 on Hungry _Joe, but then I went a little further, and put fine sandpaper on a block, and smoothed everything down. 
    Bx - > NJ ->TX!!! 
    All to get cheaper brisket! 
    ·
  • Hungry JoeHungry Joe Posts: 1,148
    +1  Come to think of it I may have done the same thing, doing it warm was 100% easier then cold.
    ·
  • ChokeOnSmokeChokeOnSmoke Posts: 1,731
    edited April 2013
    BOWHUNR said:
    This is the one you want.  I've used one to install Rutland's on all four of my eggs. 


    image
    Right on.
    Packerland, Wisconsin

    ·
  • DuganboyDuganboy Posts: 1,118
    Guys thanks so much for all the comments and especially the picture.  I posted it yesterday afternoon and then didn't have a chance to get on until this morning, and there was my answer.

    This is what makes this forum so great.
    ·
Sign In or Register to comment.