Big Green Egg - EGGhead Forum - The Ultimate Cooking Experience...
Welcome to the EGGhead Forum - a great place to visit and packed with tips and EGGspert advice! You can also join the conversation and get more information and amazing recipes by following Big Green Egg at:

Facebook  |  Twitter  |  Instagram  |  Pinterest  |  Youtube  |  Vimeo
Share your photos by tagging us and using the hashtag #EGGhead4Life.


In Atlanta? Come visit Big Green Egg headquarters, see our new showroom and check out the History of the EGG Museum and Culinary Center!  3786 DeKalb Technology Parkway, Atlanta, GA 30340.

Rutland Unglued!!

Royal CoachmenRoyal Coachmen Posts: 244
edited July 2012 in EggHead Forum
Hi all. I replaced my gasket in April with a Rutland. Unfortunately it has come unglued in a 6-8" section. Is it ok to just reglue or should I start over and replace the whole shebang? Thanks.

Comments

  • TUTTLE871TUTTLE871 Posts: 1,316

    That happened to me this weekend also. I took some Gorilla Glue and ran it under the part it coming up and closed the lid. Some leaked out a bit but I have cooked on it twice so far and had it up o 500 last night and its been holding fine so far.

    I figure if it comes up again I might redo the whole thing again.

    "Hold my beer and watch this S##T!"

    LARGE BGE DALLAS TX.

  • stikestike Posts: 15,597
    did you use rutland cement?  just peel the thing off and adhere with permatex automotive gasket maker/sealer.   it's orange, hi-temp silicone adhesive
    ed egli avea del cul fatto trombetta -Dante
Sign In or Register to comment.
Click here for Forum Use Guidelines.